Component Build-Up

Welcome to the component build-up page. This is were you assemble all your electronics onto piece 3. 

  • The fuzzy side of the velcro pieces is used on piece 3

 

 

  • Cut four small tabs of velcro and two strips.

 

 

  • Top view with velcro placed.

 

 

 

  • Side view, velcro sits just ledge to hold an ESC.

 

 

  • Bottom view, velcro holds rear ESC.

 

 

 

  • The KK2 board comes within a black foam box.
  • Cut off all the walls and stick hook side of velcro to line up with velcro on piece 3.
  • Place KK2 board over foam and poke or drill holes through foam.
  • Fasten down LIGHTLY, try not to warp the board.
  • Cut four hook side velcro pieces for your ESCs and receiver.

 

  • Receiver on top and rear ECS underneath.

Top View

Bottom View

  • Velcro right and left ESCs to the sides.

Side View

  • Plugin five servo extension wires. 
  • Make sure the orange or white wires are "in" or "up" on components.

 

 

 

 

 

 

 

 

  • Left ESC is the first motor controller and goes to M1 of KK2 controller.

 

 

  • Right ESC is the second controller and goes to M2..
  • The ESC under the receiver in the receiver is the third to M3.

 

 

SCHEMATIC

This is the TERMS OF USE  for the pieces designed and pictures associated with dragonflyRC.com

Everything associated with dragonflyRC.com can be used freely but, under Creative Commons please make sure a link references dragonflyRC.com, thanks!