Shift Tri Copter Tail Build

Step 1

  • Plug together the two sets of power extension wires.
  • 18" servo extension wire is plugged on to tail servo and body servo.
  • Place male ends of power wires with servo extension plugs and pull through tail bar.

Step 3

  • Trim one side of servo horn thats included with servo.
  • Find the center of servo shaft rotation.
  • Use original screw and place through piece 14 and servo horn into servo.
    • Have magnet part of piece 14 aligned with body of servo.

14. Servo Shoe

 

Step 4

  • The ball joint threads into the hole above numbering.
  • After joint is threaded down, place nut on back and tighten.

21. Top Tail Hinge

Linkage

Step 5

  • Clamp two number 20 pieces around aft end of the tail bar.
  • Cut mount bar to 80mm.

20. Lower Tail Hindge X2

21. Top Tail Hinge

Step 6

Magnet X2

  • Clamp the two 21 pieces around mount bar while hinge in to piece 20.
  • Press a cylinder magnet into pieces 13 and 14 with perspective to the attraction.

5. Pin Mount A

6 Pin Mount B

13. Tail Pin Coupler

14. Servo Shoe

Step 7

  • Pieces 5 and 6 clasped around piece 13, and mount bar.

4. Servo Mount X2

Step 8

  • Mount servo with two number 4's.
    • The extra 1/8" inch of the dowl from piece 13 should rest in the pivot point of piece 14.

Step 9

16.jpg
  • Two 1 1/4" bolt sets(GPMQ3545) through the pieces 21.
  • One through Piece 5 and 6, snug so piece 13 can be moved easily by servo.
  • Cut 1/4" wooden dowl a 1" or 25mm long.
  • Two more bolt sets placed through piece 23 and both 20's.

Step11

  • The heads of the servo zip ties, should be facing other side of assemble from linkage in piece 21.

 

 

15. Body Servo

  • Use the mounting harware included with servo for mounting onto piece 15.
  • A zip tie through piece 15 and around servo.

Step 13

  • Mount motor with a 1" bolt set(Dubro 178).
    • Wires of motor are facing away from assembly.

 

  • Clip the excess zip tie and tail assembly is finished.
 

 

This is the TERMS OF USE  for the pieces designed and pictures associated with dragonflyRC.com

Everything associated with dragonflyRC.com can be used freely but, under Creative Commons please make sure a link references dragonflyRC.com, thanks!