SMC Build Up

Step 1

  • Cut wooden dowl  about an 1/8" longer than the length of piece 13.

13. Tail Pin Coupler

  • Mix up 5min epoxy and put a thin coat on dowl as it is slide in from the magnet side of piece.

Epoxy

Step 3

  • Try not to have any epoxy on dowl End.

Step 4

  • Press 1/2" cylinder magnet in to piece 13.

5. Pin Mount A

6. Pin Mount B

13. Tail Pin Coupler

Magnet X2

Step 5

  • Clasp pieces 5 and 6 around 13 and tail bar.

STEP 6

  • Trim half of the servo horn so there's only one leg to it.
  • Press 1/2" cylinder magnet in to Servo Shoe taking note the attraction side.
  • The screw and horn with this coupler are included with servo.

STEP 10

  • Mount servo with two piece 4's, and zip ties.

This is the TERMS OF USE  for the pieces designed and pictures associated with dragonflyRC.com

Everything associated with dragonflyRC.com can be used freely but, under Creative Commons please make sure a link references dragonflyRC.com, thanks!